Our Model T-110 Dupli-Carver® is designed to fill the needs of a hobbiest or craftsman with the same accuracy and versatility of our professional models. The T-110 is a lighter machine and is used on a table, bench or stand, and requires a work area of only 2' by 4'. Our machines are supplied with skid resistant rubber feet under the leg base boards so that the machine will not slide or damage your bench surface.

This affordable machine can carve an amazing 8" diameter by 18" tall. The T-110 uses a spring system to balance the lower arm. The upper arm is balanced with an adjustable counterweight chamber. The unit is supplied with a functional bit guard, speed control, and a router. If you are looking for a duplicator for a small investment, the T-110 is the machine for you. The T-110 comes with 4 router bits (#100, 101, 105, 109), 4 styli (#301, 305, 308, 309), all assembly hardware, Operator's and Assembly Manual. Assembly is required.

The T-110a Spindle Carver expands the capabilities of the T-110 to 30" long by 8" in diameter. The carriage consists of a set of tubes that slide through the table legs and cross members that support the work pieces in a horizontal position. Table legs, candle holders, and gunstocks are easily and accurately carved with this accessory. Both turntables are linked together so that the objects rotate in unison through 360°. The carriage slides forward and back to allow you to carve the entire 30" length without remounting the work piece. Comes complete with operating instructions and all assembly hardware.

FOR A PRINTABLE VERSION
OF THIS PAGE