Having trouble finding tooling that can handle hard trowel down coatings without wearing out in just a couple thousand square feet? The answer has come in the formulation of the 948FS. The Speed Stic (948FS) was designed to handle the most aggressive applications; MMA, KoolDeck® , etc. The Speed Stic can travel over/through joints, bolts, studs, etc with no damage to the tooling. NOT PCD

ONLY AVAILABLE FOR THE SPEED SHIFT SYSTEM

Item # SM-816

Polycrystalline Diamond (PCD)

The sharksteeth PCD is used for the removal of thick mil coatings such as: double broadcast, trowel downs, slurries and thinset. PCDs are available for use with universal tool plates and speed shift plates. Since the tooling is directional plug stones will not work.

Item # SM-542

REMOVING EPOXY USING PCD'S ON A MODEL 3100-3P

The Epoxy Cutter BED is available in the blue bond. This formulation has an increased diamond concentration to sustain longer tool life when removing thin mil coatings such as: thin film epoxy, carpet glue and mastics. Epoxy Cutters are available for use with plug stone holders, universal tool plates and speed shift plates.

Item # SM-529

The Epoxy Shaver PCD is best when used for thin film removal where a strong profile is required to the substrate. (A much stronger profile than epoxy cutter disks). Epoxy Shavers are ideal for hard troweled concrete where an aggressive stone is required to break through the surface. The epoxy shavers also go by the name Trowel Busters. Epoxy Shavers are available for use with universal tool plates and speed shift plates.

Item # SM-723 (CW)
Item # SM-724 (CCW)

The XB95 FLAT is a special shape of the XB90 formula, which is available in 30 grit only. It has been designed for use on the Terrco models 3100 and 6200 when removing elastomeric coatings such as pedestrian or traffic deck coatings. They are also exceptional on very abrasive soft concrete. The XB95 FLAT is only available for the speed shift system.